The galley wall faucet’s nipple-ectomy was a success! We had replaced the tapered brass nipples and I just got the fresh union washers of the correct size. And now… Let there be water. I’ll add an aluminum L backsplash later.The other trick was to buy an adjustable slip-nut plumber’s wrench from Home Depot, in order to tighten all the threaded connections by two or three more turns than was possible by hand.
Once it all went together, I decided I need to add a 12V switch for just the water pump’s branch so that its parent circuit (which is shared by the overhead lights and the 12V galley ports) could be left powered ON at the helm, but OFF at the pump most of the time. So with this lighted toggle switch wired in at the galley, you would have to explicitly turn the pump ON when you need water and then turn it back OFF to be safe. This should help prevent any future disaster where the system springs a leak unattended.
And finally, I got inspired today by that new Insane Pools show on Animal Planet about building custom backyard oases (yes, that’s the plural form of oasis). So next weekend, my friend Gary Jackson is coming to install these beautiful sea glass mosaic tiles on the faces of the RETROpad’s two curb steps. Aesthetically, the 1-inch tiles represent computer pixels to me, but overall it’ll create that shimmering turquoise water effect everyone loves.
32 sheets cost $415 including shipping from Glass Tile Oasis in New Jersey. The sheets are 12×12 inches each, so we’ll simply cut each one in half to make two 6-inch by 30′-7″ strips with one spare sheet in case of defect. Gary will then thin-set them into place using his mud-working superpowers. Should be fun!